To Engage Track Drive
•With the engine running near top speed, move the shift lever into one of the six FORWARD positions or two REVERSE positions. Select a speed appropriate for the snow conditions that exist.
NOTE: Use slower speeds in higher snow and until you are familiar with the operation of the snow thrower.
•Squeeze the traction control against the right handle and the snow thrower will move. Release it and the drive motion will stop.
IMPORTANT: NEVER move the shift lever without first releasing the traction control. Doing so will cause premature wear to the drive system’s friction wheel.
To Engage Augers
To engage the augers and start the snow throwing action, proceed as follows:
•Squeeze the auger control against the left handle. To disengage power to the augers:
•Release both the auger control and the traction control, if engaged.
The auger control can be locked so you can turn the
electric chute directional control without interrupting the snow throwing process.
Operating Tips
NOTE: Allow the engine to warm up for a few minutes. The engine will not develop full power until it reaches operating temperature.
WARNING: The temperature of the muffler and the surrounding areas may
exceed 150°F. Avoid these areas.
•For the most efficient snow removal, remove snow immediately after it falls.
•Discharge the snow downwind whenever possible.
•Slightly overlap each previous path.
•Set the skid shoes 1/4" below the shave plate for normal usage. The skid shoes may be adjusted upward (to lower the shave plate) for
•Be certain to follow the precautions found in the To Stop Engine section to prevent possible
•Clean the snow thrower thoroughly after each use.
SECTION 5: MAKING ADJUSTMENT
WARNING: NEVER attempt to make any adjustments while the engine is running, except where specified in the operator’s manual.
Auger Control Adjustment
Refer to the information found under Final Adjustments in the Assembly Section to adjust the auger control.
Traction Control Adjustment
Refer to the information found under Final Adjustment in the Assembly Section to adjust the traction control. If you are uncertain that you have reached the correct adjustment, proceed as follows:
WARNING: Drain the gasoline out of the snow thrower’s tank, or place a piece of plastic film under the gas cap to avoid spillage BEFORE making the adjustment.
•Tip the snow thrower forward, allowing it to rest on the auger housing.
•Remove the frame cover underneath the snow thrower by removing the six
•With the traction control released, there must be clearance between the friction wheel and the drive plate in all positions of the shift lever.
•With the traction control engaged, the friction wheel must contact the drive plate. See Figure 9.
Gear Shaft | Drive |
Cable | |
Friction Wheel | Pivot Rod |
| |
Rubber |
|
| Drive |
| Plate |
Figure 9
If adjustment is necessary:
•Loosen the jam nut on the traction drive cable. Adjust the cable as necessary. Refer to Figure 5.
•Retighten the jam nut to secure the cable when correct adjustment is reached.
•Reassemble the frame cover.
NOTE: If you placed plastic film under the gas cap, be certain to remove it before operating the snow thrower.
10
