White Rodgers 1C30(W) installation instructions 1C30W / 1D30W, Description, Precautions, Contents

WHITE-RODGERS	1C30(W) / 1D30(W)
	Low Voltage Heating Thermostat
	INSTALLATION INSTRUCTIONS

Operator: Save these instructions for future use!

FAILURE TO READ AND FOLLOW ALL INSTRUCTIONS CAREFULLY BEFORE INSTALLING OR OPERATING THIS CONTROL COULD CAUSE PERSONAL INJURY AND/OR PROPERTY DAMAGE.

This low voltage thermostat is designed to provide conve- nient control of the heating system. To provide greater room comfort, the sensitive spiral bimetal is combined with an adjustable heating anticipator to provide maxi- mum comfort.

1C30

DESCRIPTION

1D30

If in doubt about whether your wiring is millivolt, line, or low voltage, have it inspected by a qualified heating and air conditioning contractor, electrician, or someone familiar with basic electricity and wiring.

Do not exceed the specification ratings.

All wiring must conform to local and national electrical codes and ordinances.

CONTENTS
Description	1
Precautions	1
Specifications	2
Installation	2
Select Thermostat Location
Route Wires to Location
Attach Thermostat to Wall
Operation & Maintenance	3
Adjusting Heat Anticipator
Calibrating Thermostat

PRECAUTIONS

This control is a precision instrument, and should be handled carefully. Rough handling or distorting compo- nents could cause the control to malfunction.

!CAUTION

To prevent electrical shock and/or equipment damage, disconnect electric power to system, at main fuse or circuit breaker box, until installation is complete.

Do not short out terminals on gas valve or primary control to test. Short or incorrect wiring will burn out heat anticipator and could cause personal injury and/or property damage.

!WARNING

Do not use on circuits exceeding 30 volts. Higher voltage will damage control and could cause shock or fire hazard.

ATTENTION!

This product does not contain mercury. However, this product may replace a unit which contains mercury. Do not open mercury cells. If a cell becomes damaged, do not touch any spilled mercury. Wearing non-absorbent gloves, take up the spilled mercury with sand or other absorbent material and place into a container which can be sealed. If a cell becomes damaged, the unit should be discarded. Mercury must not be discarded in household trash. When the unit this product is replacing is to be discarded, place in a suitable container and return to us at WHITE-RODGERS.

WHITE-RODGERS DIVISION	PART NO. 37-5584A
EMERSON ELECTRIC CO.	Replaces 37-9599A
9797 REAVIS RD., ST. LOUIS, MO. 63123
(314) 577-1300, Fax (314) 577-1517	9531
Printed in U.S.A.
9999 HWY. 48, MARKHAM, ONT. L3P 3J3
(905) 475-4653, FAX (905) 475-4625

R