White Rodgers 1F98EZ-1421, 1F98EZ-1441 Choose the System Mode Cool, Off, Heat, Em, Auto

	Choose the System Mode (Cool, Off, Heat, Em, Auto)
	Touch the SYSTEM key to select:
	Cool: Cooling is on.
	Off: Heating and Cooling are off.
QUICK	Heat: Heating is on.
	with heat pump systems (see page 9).
START	Em: Emergency heat setting available only
	both heating and cooling may be
	Auto: Auto Changeover is used where
	required during the same day. Auto
	allows the thermostat to automatically
	select heating or cooling depending on
	the indoor temperature and the selected
	heat and cool temperatures. The desired
	temperature must be equal to or higher
	than the desired temperature for cooling
	when using auto changeover.

Energy Saving Factory Pre-Program

• Select humidifier pad maintenance

reminder. Scrolling message will

show “HUMIDIFIER PAD MAINTE-

NANCE”. Default is OFF. It can be

changed to a setting from 25 to 1975

hours in increments of 25 hours to

select the amount of time for the

reminder. Setting of 100 hours is typi-

cally 6 months of run time.

Based on this setting, the scrolling

message area will show “CHANGE

HUMIDIFIER PAD” to indicate main-

tenance is required.

• Select beeper (audio prompt)

Default is On for the beeper to sound

with any touch key press. It can be

changed to OFF.

• Select continuous display light.

Scrolling message will show “DIS-

PLAY LIGHT”.When selected ON, the

1

1

2

2

SET-UP

This touchscreen thermostat is programmed with the energy saving settings shown in the table below for all days of the week. If this program suits your needs, simply touch the Run Schedule key.

Factory Pre-Programmed heating and cooling schedule for all days of the week

Wake Up	Leave For Work	Return Home	Go To Bed
(Morning)	(Day)	(Evening)	(Night)

Heating Program 6:00 AM 70°F 8:00 AM 62°F 5:00 PM 70°F 10:00 PM 62°F

Cooling Program 6:00 AM 75°F 8:00 AM 83°F 5:00 PM 75°F 10:00 PM 78°F

If you wish to set your heating and cooling schedule to something other than the factory pre-programmed settings, please proceed to the “Programming Your Thermostat” section.

display light will be on continuously

with power to the system. Selecting

OFF will allow the display light to

turn on momentarily when any key is

touched. If system power is off, and

thermostat is operating on battery

only, the display light will not turn on.

1

2

8 13