Whynter ARC-13PG instruction manual

18

	The unit is set to low fan speed.	Set the unit to a higher fan speed.
The unit has worked for a long	Windows or doors are open.	Close all windows and doors.
time, but the room is not cold
enough	There are too many people in the room.	You may need additional cooling or another air conditioner.
	There is direct sunshine into the room.	Close curtains or blinds and try to minimize the amount of direct sunlight
		into the room.
	The room is a kitchen or with many heat-	You may need additional cooling or another air conditioner.
	producing appliances
	There is a server in the room.	You may need additional cooling or another air conditioner.
	The room is too large.	You may need additional cooling or another air conditioner.
The unit is very noisy	The unit is not level.	Make sure the unit is on hard, level and stable surface.
	The surface underneath the unit is uneven.	Move the unit to a location with a level and hard floor.
	Low power voltage.	Make sure the wall outlet and support the required power consumption
		of the air conditioner and do not use an extension cord.
The unit leaks water	The unit is tilted or not leveled	Make use the unit is leveled.
	The water tank is full.	Drain water from the drain plug at the back of the air conditioner.
Fan speed cannot be changed	Fan speed differences are not very noticeable	The fan speed difference is not very noticeable when the compressor is
		on. Try setting the unit to Fan only mode, you should be able to hear the
		difference between high and low fan speed settings.
F1 error message	Air filter needs to be clean.	Clean the air filer.
		Once the filter is installed, press and hold the power button for 10
		seconds to reset the F1 code. A beep sound will indicate a
		successful reset process.
		*The F1 message may not go away immediately. If the unit is cooling
		properly, the F1 message does not affect the performance of the air
		conditioner.