C500AP Airpot Coffee Brewer
START-UP
1.Remove top cover of brewer. Remove lid from heating tank. Hand fill tank until water level is approxmately two inches below probe tip.
2.Connect the water line to the brewer using ¼" copper tubing with ¼" female flare fitting.
3.Turn on water.
4.With top cover removed, locate the thermostat (see illustration, page 8, #37), turn the thermostat shaft clockwise until it stops. The BREW READY indicator light will go off when the thermostat is on.
5.Plug unit into power supply outlet and flip power switch (behind unit) to ON position. Turn ON/OFF switch to ON position. Water should flow into heating tank. Check to see that the water stops flowing when it reaches the probe tip. When this is verified, replace the tank lid and top cover of machine.
6.The
COFFEE BREWING
1 | Pour ground coffee into the filter and brew |
cone. |
2
3
Slide the brew cone onto the guide rails as far in as it will go.
Place an empty, open airpot on the deck be- neath the brew cone. Push the BREW SWITCH to start. Hot coffee will start to flow from the brew cone.
!CAUTION HOT LIQUID. BREW INTO AN EMPTY AIRPOT ONLY. DO NOT REMOVE BREW CONE UNTIL IT HAS COMPLETELY DRAINED.
[ 2 ]