WiLife V 1.5 EXPOSURE TO MOISTURE , FIRE HAZARDS , SHARP EDGES , CHOKING, SUFFOCATION AND STRANGULATION HAZARDS , USE WITH THIRD PARTY DEVICES , VENTILATION

•

Affix the mount to the wall or ceiling using the instructions provided in this manual.

•

Ensure the camera cable is routed in such a way as to preclude accidental pulling the camera off the

wall or ceiling.

If, after falling, the camera exhibits degraded performance, has ceased operating, shows visible cracks or if

there is evidence that internal components have come loose, disconnect the camera from its cable and follow

the instructions in this manual for obtaining service repair.

EXPOSURE TO MOISTURE

The LukWerks equipment is designed to be used only in dry, indoor environments. Do not use this system near

water; for example, near a bath tub, washbowl, kitchen sink, or laundry tub, in a wet basement, or in or near a

swimming pool. Exposure to rain, mists, excessive humidity and liquid emersion will likely cause significant

degradation in system performance and utility. If any LukWerks component has been exposed to moisture,

immediately unplug all components from power outlets and allow the components to dry completely before

attempting to reinstall the equipment. If, after drying, the system exhibits degraded performance, disconnect

the system from all power sources and follow the instructions in this manual for obtaining service repair.

FIRE HAZARDS

Care should be taken to keep LukWerks equipment and packing material away from open flames and

temperatures in excess of 34°C (93°F). Care should be taken to keep electrically conductive objects from

falling between the Luk camera power supply and the LukWerks HomePlug®/USB Bridge and the wall plug,

potentially shorting out the AC power and causing a fire. If the case of any LukWerks equipment becomes

open, cracked or broken in any way disconnect the power source to the component and refer to the service

repair section of this manual.

SHARP EDGES

Under normal circumstances LukWerks system components are safe to handle. If the LukWerks components

are exposed to significant physical shocks, the LukWerks enclosures could break open exposing sharp

enclosure edges and sharp internal component edges. In the event of enclosure breakage, carefully remove

affected components from their power source and follow the service procedures of this manual.

CHOKING, SUFFOCATION AND STRANGULATION HAZARDS

Care should be taken to keep LukWerks equipment and packing material away from small children and

persons with diminished mental capability. Specifically, the camera lens might be unscrewed and accidentally

swallowed. The wall/ceiling mount screws and anchors could be accidentally swallowed. The LukWerks cables

could also be accidentally swallowed or become wrapped about a neck. If the LukWerks components are

exposed to significant physical shocks, the LukWerks enclosures could break open and small internal

components could come loose and become a choking risk. Plastic packing material may present a suffocation

hazard to small children and persons with diminished mental capability. Please properly dispose of all packing

material.

USE WITH THIRD PARTY DEVICES

Do not plug the LukWerks cables into any device other than the intended LukWerks components. Doing so

could damage the equipment and expose the user to fire and electrical shock hazards. The LukWerks

equipment is specifically NOT compliant with “power over Ethernet” standards such as IEEE 802.3af.

VENTILATION

Keep the area around LukWerks components free of materials that may obstruct airflow and proper ventilation

of the components. This system should never be placed near or over a hot radiator or heat register. This

system should not be placed in a built-in installation unless proper ventilation is provided.