7
CHANGING THE PFM T32 FREQUENCY
FIG. 5: PFM T32 FREQUENCY CHANGE
By default, the T32’s frequency is to set 72.9 MHz (Channel E). If you experience FM interference,or
if you need to match a receiver’s frequency,it may be necessary to adjust the frequency on the T32.
Instructions:
1.Open the battery compartment using a coin in the slot in the bottom of the transmitter. Remove the
batteries.
2. Lift the battery compartment door up and pull to your left to expose the circuit board.
3.Refer to FIG 5 to locate the Channel Switch.
4.Use a small screwdriver to rotate the Channel Switch to correspond with the desired operating fre-
quency. Choose between 16 standard channels. Refer to the Channel Selection Chart in FIG 5for
available channels.
5. Reinstall the batteries, then close the back of the transmitter.
6.Plug the microphone in and turn the transmitter on to provide a tuning signal for the receivers.
Important:Make sure all receivers being used match the frequency of the transmitter. Refer to the
receiver’s instruction manual for frequency change instructions.