Introduction
This manual includes operating and maintenance instructions for the Wilton
Cut-Off Saw Features
Refer to Figure 1 and 2 for cut-off saw features
Blade Guide Supports | Blade Wheel Cover | |||
|
|
| Blade | |
Control |
|
| Speed | |
Panel |
|
| Control | |
|
|
| Coolant Sump | |
|
|
| Access Panel | |
Blade Guides |
|
|
| |
Saw | Base | Coolant | Coolant | |
Blade | ||||
Temperature | Overflow | |||
|
| |||
Figure 1: Saw Features (Front View)
| Hydraulic | Saw | Blade |
| |
| Cylinder |
| Tension |
| |
|
| Head |
| ||
|
|
| Handwheel | ||
|
|
|
| ||
|
|
|
|
| Vise |
|
|
|
|
| Handwheel |
Drive |
|
|
|
|
|
Motor |
|
|
|
|
|
|
|
|
|
| Coolant |
Hydraulic Pump |
|
|
| Pump | |
Electrical |
| Access | |||
and Reservoir |
| Work Table | Panel | ||
| Panel |
| |||
|
|
|
| ||
Figure 2: Saw Features (Rear View)
Operating Instructions
Controls
The operating controls for the saw are provided in a control panel on the left side of the machine. The control panel is mounted on a pivoting tube. The pivoting tube allows the operator to position the control panel in a convenient location.
Saw Head Up |
|
| |
Light | Saw Head Down |
|
|
|
|
| |
| 1 | 0 |
|
| 10 |
| |
Start | 2 |
| 9 |
3 |
| 8 | |
Switch |
| ||
4 | 7 | Feed Rate | |
| 5 | 6 | Knob |
Stop |
|
| |
0 |
|
| |
|
|
| |
Switch |
|
|
|
|
| Capped Openings | |
Emergency Stop | |||
| Coolant Pump Switch |
| |
Figure 3: Control panel
The upper row of controls include the following:
1.Power On light indicates when power is con- nected to the machine.
2.Saw Head Up pushbutton is used to raise the head.
3.Saw Head Down pushbutton is used to lower the head onto the workpiece.
The center row of controls include the following:
1.Start pushbutton is used to start the saw blade drive motor and the hydraulic pump motor. The hydraulic pump provides the hydraulic pressure required to raise and lower the saw head.
2.Feed Rate control is used to set the rate at which the blade feeds through the workpiece.
7
Variable Speed Adjustment From
25 MPM TO 75 MPM
Recommended Speed for Cutting Various Materials
SPEED/MPM | Material To Be Cut |
25 | Tool Steel, Stainless Steel, Alloy Steel, Phosphor |
| Bronze, Hard Bronze, Hard Cast Iron, Malleable Iron. |
|
|
40 | Mild Steel, Soft Cast Iron, Medium Hard |
| Brass, Medium Hard Bron |
50 | Soft Brasses and Bronzes, Hard Aluminum, Plastics |
75 | Plastics, Soft and Medium Soft Aluminum, |
| Wood, Other Light Materials |
|
|
