Wind Crest CTG304D, CTG365D Cleaning And General Care, Electronic Ignition, Grates, Control Knob

Electronic Ignition

Each burner has an igniter that sparks when the burner is turned on, or during re-ignition if the flame is extinguished. When a flame is present the igniter will stop sparking. If a cross draft is present the flame can be affected and some sparking can occur. This is normal.

The igniter can get dirty due to normal cooking splatter or spills. This may cause nuisance sparking. The igniter can be cleaned by using a Scotch Brite cleaning pad to clean the igniter disk. Do not touch the igniter on the burner if the control is in the ON position. Hold the pad against the igniter tip and using light pressure rotate the pad in a circular motion. A few rotations are usually sufficient to clean the surface.

If a burner does not ignite in approximately 4 seconds, check the positioning of the burner head to be sure the tabs and notches are properly aligned.

Grates

Grates are to be properly installed onto cooktop.

Model CTG304D – Has two symmetrical grates. Position side by side into recessed area of cooktop over burners.

Model CTG305D – Has two non-symmetrical grates. Position side by side into recessed area of cooktop over burners. Center burner section of grates match each other over center burner.

Model CTG365D – Has three grates; two larger symmetrical grates and one smaller center grate. Position larger grates into recessed area of cooktop on each side of control area. Smaller center grate fits between the larger grates.

CAUTION: THE GRATES ARE HEAVY. USE BOTH HANDS AND SPECIAL CARE WHEN LIFTING. PROVIDE SURFACE PROTECTION WHEN PLACING ON COUNTERTOP.

CLEANING AND GENERAL CARE

CAUTION: CONTROLS SHOULD BE OFF AND SURFACES COOL BEFORE CLEANING.

Control Knob

When in place on cooktop, wipe with a damp cloth. A mild soap solution can be used. Do not soak. If removed and cleaned, be sure the knob has dried fully before reinstalling.

DO NOT FORCE KNOB ONTO CONTROL STEM. ALIGN THE FLAT ON STEM WITH THE FLAT ON KNOB AND GENTLY PUSH INTO PLACE.

Burner Base

Use cloth or Scotch Brite pad dampened with a water and detergent solution. Rub in circular motion.

AVOID SCRATCHING STAINLESS STEEL WITH SCOTCH BRITE PAD.

Burner Head

Scotch Brite pad dampened with a water and detergent solution. Rub in circular motion.

AVOID USING HARSH SCOURING PADS AND ABRASIVE CLEANERS.

If parts become clogged, clean using a paper clip. Do not use toothpick, which can break and clog the parts.

10