INSTALLATION INSTRUCTIONS
HOOD MODELS WSL, WCL, & WER
By CNP INDUSTRIES, INC.
P.O. Box 18645 Anaheim, Ca 92817 (877)
IMPORTANT: Save these Instructions for the Local Electrical Inspector's use.
INSTALLER: Please leave these Installation Instructions with this unit for owner.
OWNER: Please retain these Instructions for future reference
IMPROTANT SAFETY INSTRUCTIONSWARNING - TO REDUCE THE RISK OF FIRE, ELECTRICAL SHOCK, OR INJURY TO PERSONS, HOODS SHOULD BR INSTALLED WITH VENTILATORS APPROVED FOR USE WITH THE HOOD. SEE TABLE 1 OF THIS INSTRUCTION FOR APPROVED VENTILATORS.
WARNING - TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING:
A. Installation work and Electrical Wiring Must be Be Done By Qualified Person(s) In Accordance With All Applicable Codes & Standards.
Including
To Reduce The Risk Of Fire, Use Only Metal Duct Work.
B. Sufficient air is needed for proper combustion and exhausting of gases through the flue (chimney) of fuel burning equipment to prevent backdrafting. Follow the heating equipment manufactures guideline and safety standard such as those published by the National Fire Protection Association (NFPA) and the American Society for Heating, Refrigeration and Air Conditioning Engineers (ASHRAE), and the local code authorities.
C. When cutting or drilling into wall or ceiling, do not damage electrical wiring and other hidden utilities.
D. Before Servicing or Cleaning Unit, Switch Power off At Service Panel And Lock Service Disconnecting Means to Prevent Power From Being Switched On Accidentally. When The Service Disconnecting Means Cannot be Locked, securely Fasten A Prominent Warning Device, Such As A Tag, To The Service Panel
CAUTION - TO REDUCE THE RISK OF FIRE AND TO PROPERLY EXHAUST AIR, BE SURE TO DUCT AIR OUTSIDE FOR DUCTED FANS DO NOT VENT EXHAUST AIR INTO SPACE WITHIN WALLS OR CEILING OR INTO ATTICS, CRAWL SPACES OR GARAGES.
Read this instruction completely before starting installation. Planning the complete installation before starting any work is highly recommended. This includes all aspects of the installation including hood location, ducting, electrical requirements, and adequacy of mounting surfaces.
| TABLE - 1 | This hood has been designed to be used with the ventilators shown in |
| Use model VEN030I or VEN060I | Before cutting into cabinets, it is necessary to confirm that the correct ventilator |
| for internal ventilator. Use | is being used. Your dealer should have reviewed your needs prior to your |
| VEN060E, VEN120E, VEN100E | purchase. Be sure you have the correct ventilation system. |
| or VEN140E for remote ventilator | CAUTION: To Reduce The Risk Of Fire And Electrical Shock, Install This |
| Rangehood Only With Blowers Manufactured By Wind Crest. |
|
DUCTING: Use a minimum 8" round duct for VEN030I, VEN060I and VEN060E installations. Use a minimum 10" round duct for VEN120E, VEN100E, VEN140E and