Wind Crest WPN C L Hood, Spacing To, BE 1/8, Larger Than, Duct Cover, Being Used

1)Decide on hood location, position above cooking surface and type of air discharge to be used (See Hood

Installation Instruction). When using the Duct Cover(s) plan on spacing from the top of the hood to the ceiling 1/8” larger than the duct cover length being used. This allows assembly of the duct cover after installation of the hood, electric connections and ducting. The small gap, at top of duct, remaining after installation will not be noticeable in most applications. If necessary a small quarter-round can be used to this gap at the ceiling interface.

SPACING TO

BE 1/8"

LARGER THAN

DUCT COVER

BEING USED

2)When using the duct cover and hood, locate hood centerline on wall and mount the Duct Cover Bracket to ceiling centered on the hood centerline, use #8 x 1-1/2” screws to mount bracket. Mount the bracket to the ceiling with edge “A” against the hood-mounting wall. Wood framing should be located, behind wallboard, in the area of the ceiling. If not, use anchors to fasten bracket to ceiling.

SECURE

TO

CEILING

A

CEILING

DUCT COVER

BRACKET

C

L HOOD

SECURE W/2 #8 SCREWS

WALL

The Duct Cover Bracket is used to ensure the Duct Cover is retained against the wall, for appearance purposes, when the longer length of cover is used.