TO STOP SCRUBBING
1.Rotate the function knob to either transport position. The brush motors will stop and the scrub deck will rise to the park position. After 10 seconds the squeegee will raise, and 10 seconds later the vacuum motor will turn off. This delay is to clear the vacuum hose of recovered solution.
2.Allow the throttle pedal to return to neutral.
3.Turn machine power off.
FOR SAFETY: Before leaving or servicing
machine: stop on level surface, turn off machine and remove key.
MACHINE OPERATION
DOUBLE SCRUB
For floors which are heavily soiled or have thick accumulations of floor finish, may not clean sufficiently with one pass. In these cases it will be necessary to double scrub.
Rotate the knob to the double scrub position labeled “C”, make the first pass over the surface being cleaned with the squeegee up, vacuum off and the solution on. For best results also remove the Aqua- mizer™, this will allow the solution to stay in contact with the soil while loosening the surface accumulation with the brushes. Allow time for the first application to stay in contact with the floor. Length of time between the first and second pass depends on amount of accumulation and the type of chemical being used. A second scrubbing with the function knob in one of the normal scrubbing modes will lower the squeegee and will keep the solution on and brushes down to further loosen soil. The additional application of solution will further assist the difficult cleaning job.
FOR SAFETY: When using machine, go slow on inclines and slippery services.
86317500 CHARIOT SCRUBBER 11/15/08 |
|
