REMOVING OR REPLACING BAG
1.Disconnect batteries and make sure parking brake is not overridden.
2.Remove Dome and set aside.
3.Drain all solution from both sides of the bag and rinse well.
4.Remove float cage, loosen screw on elbow and remove elbow. (You can remove the bag by only removing the float cage and sliding the bag opening over the elbows.)
5.Remove threaded mandrel from the bottom of the bag. Turn counterclockwise, remove by grabbing the attached handle. The mandrel washer should come off with the mandrel.
6.Lift the bag assembly out of the tank. The dome gasket, plastic collar, and metal frame can all be removed as one assembly. The bag can be cleaned as an assembly or further disassembled.
7.To replace with a new bag remove the four screws that go through the collar and into the frame. Feed the frame through the loops at the top of the bag.
MAINTENANCE-BAG REPLACEMENT
8.
9.Place bag assembly into tank.
10.Align bag drain hole with fitting in bottom of tank and thread in mandrel with washer attached. Turn clockwise to tighten. Tighten only by hand, do use a tool. Ensure mandrel is tight, the bag should be unable to move or spin around the mandrel.
11.Seat the collar, gasket, frame assembly to the tank rim opening. At the same time slide the vacuum collar opening over the float cage elbow assembly.
12.Replace the rest of the elbow and float cage assembly with its mounting screw, if it was removed.
13.Install dome and connect squeegee hose.
86317500 CHARIOT SCRUBBER 11/15/08 |
|
