Windsor SC264, SCC264, 10052250, 10052210 4-14, Machine Troubleshooting, Problem, Cause, Solution

MACHINE TROUBLESHOOTING

PROBLEM	CAUSE	SOLUTION
Little or no solution flow to the	Solution tank empty	Fill solution tank
floor
	Solution flow turned off or	Turn on or increase flow
	set too low	setting
	Solution strainer plugged	Clean solution strainer
	Solution hoses obstructed	Clear obstruction from
		hose
	Solution solenoid valve	Clean or replace
	obstructed or stuck
	Vent hole in solution tank	Clear obstruction from vent
	lid obstructed	hole
No power to machine	Battery disconnected	Check all battery cable
		connections
	Emergency shut-off	Reset
	activated (If included)
	Battery connections	Clean connections
	corroded
	Faulty main contactor	Replace contactor
	Faulty key switch	Replace switch
Little or no propel	Low battery charge	Charge batteries
	Wheels spin	Decrease brush pressure
	Controller overheated	Allow cool down period
		Adjust brush shroud if
		needed
	Loose connection	Check motor wires and
		connection

4-14 CUTTER 24V 86039070 04/10/07