Windsor SCX364, 10052410 manual Machine Troubleshooting, Problem, Cause, Solution

MACHINE TROUBLESHOOTING

PROBLEM	CAUSE
Poor or no water pick-up	Squeegee out of adjustment
on either squeegee
	Debris caught on squeegee
	Worn squeegee blades
	Vacuum hose clogged
	Vacuum hose disconnected
	from squeegee or recovery
	tank
	Vacuum hose damaged
	Recovery tank not sealed
	Foam filling recovery tank
Vacuum motor does not run, or	Recovery tank full
runs slowly
	Recovery tank float system
	dirty
	Circuit breaker tripped
	Loose connection
	Faulty vacuum switch
	Worn vacuum motor
	brushes
Poor scrubbing performance	Debris caught in scrub
	brushes
	Worn brushes or pads
	Improper detergent, brush or
	pad used
	Low scrub brush down
	pressure
	Low battery charge
Brush motors do not run, or runs	Circuit breaker(s) tripped
slowly
	Loose connection
	Faulty brush motor contactor
	Worn brush motor brushes

SOLUTION

Adjust squeegee Remove debris

Rotate or replace squeegee blades

Clear obstruction from hose

Reconnect vacuum hose Replace vacuum hose Place recovery tank dome on tank. Replace damaged gaskets. Empty recovery tank

Use less or different detergent Use defoamer

Drain recovery tank

Clean float system Reset circuit breaker Check motor wires and connections Replace switch Replace brushes, check commutator

Remove debris

Replace brushes or pads Contact equipment or application specialist

Increase brush pressure

Charge batteries

Reset circuit breaker(s) Check motor wires and connection

Replace contactor Replace brushes, check commutator

4-16 SCX364 86037150 1/17/07