OPERATION
CONTROLS
1.Safety Lock – Prevents unintended operation of the machine.
2.Switch Levers – Turns machine on/off.
3.Adjustment Handle – Allows the handle to be adjusted to a comfortable operating position.
1
22
LOCK
UNLOCK
3
The handle adjust bar (14344) for the polishers are individually preset at the factory for optimum locking efficiency and minimum effort of engaging. It should not be necessary to adjust the handle adjust bar unless the relationship of the handle adjust bar nut (57275) or fixed clamp bolt (70692) and their corresponding nuts (57275) and washer (87086) have been disturbed. The handle can be positioned to be locked with the handle adjust bar pointing either up or down. In order to change the position the handle and bolt must be removed and rotated 180 degrees. It is incorrect to make it lock opposite from the way it was assembled by applying more force to the nut. From the factory the locking is in the up position when the machine handle is locked. The pivot pin (66334) on the handle adjust bar is off center, in relationship of the screw to the axis of the (see drawing). To adjust handle adjust bar, tighten nut on handle while in the locked position. The handle is locked when the screw is to the outside of the machine and the flat on the opposite side of the handle is flush to the bracket.
1.To adjust handle lock, tighten nut on handle while in the locked position. Optimum locking force and ease of locking is accomplished when the locking lever nut is set to a torque of 30 to 50 inch pounds in the locked position.
2.Gap between clamp halves at the front should be to the gap in rear when the handle adjust bar is adjusted properly and in the locked position (gap approximately 1/16").
1 4 3 4 4
87202
67430 
70692 
57275 (2) 2
87086
1
S H O W N H A N D L E I S |
IN LOCK POSITION |
66334
PIVOT PIN C L
HANDLE CL 
LOCKING SIDE FLAT
STORM POLISHER 980100 03/08/03 | |
|
