!
CAUTION
For indoor use only.
To prevent possible damage to the floor when using the brush option, use water or other approved cleaning solution while operating. When using the pad option, always keep the machine moving when in contact with the floor.
! 
WARNING
High starting torque. Hold machine firmly with both hands.
1.Ensure that the pad driver or brush is installed correctly and in good shape. Install or change pad if necessary.
2.Plug the machine into a wall outlet as described in the grounding instructions.
3.Lower the handle by unlocking the adjustment handle and moving the handle into position. Relock the handle when it is in a comfortable position.
! 
WARNING
Insure that handle is locked in position before starting machine.
4.Push the safety lock forward, unlocking the switch levers.
5.With the safety lock forward, squeeze one or both of the switch levers, turning the machine on. (These levers can be operated independently of each other). The safety lock will not
6.To stop the machine, release both of the switch levers.
NOTE: The machine is equipped with a circuit breaker to protect the motor in the event an overload condition occurs. The circuit breaker is located on the rear of the motor. Push the reset button to restart the machine. If the breaker trips again, correct the cause of overloading before proceeding.
OPERATION
DAILY MAINTENANCE
1.Inspect power cord for wear. To prevent electrical shock replace cords with frayed or cracked insulation immediately.
2.Place machine in the storage position.
3.Check pad condition. Change if soiled or torn.
PAD DRIVER INSTALLATION
1.Lay machine back, exposing the under side.
2.Place pad driver on the motor lug and rotate clockwise until engaged. To remove, turn
STORM POLISHER 980100 03/08/03 | |
|
