EXTENSION CORDS:
If an extension cord is used, the wire size must be at least one size larger than the power cord on the machine, and the cord must be a type SJTW/SSTW:A.
HOW IT OPERATES
The TRIDENT COMPACT is a
Detergent solution and water flow from the solution tank to the scrub brush. The rotating brush scrubs the floor. As the machine moves forward, the rear squeegee collects the dirty solutionandchannelsit intothevacuum of the squeegeepickup hose. The pickup hose deposits the dirty solution into the re- covery tank.
PREPARING FOR OPERATION
(PERFORM DAILY MAINTENANCE AS SHOWN ON
PAGE 7.)
Fill Solution Tank
1.) | Remove cover and fill. (see item 19, page 14) |
2.) | Use a clean bucket or hose to fill the tank |
with water.
3.) Add a cleaning concentrate for use in automatic floor scrubbers. Closely follow the manufacturer’s instructions found on container. Read ingredients listed on the container to ensure compatible chemicals are used.
Use only the suitable chemicalslisted below. Using incom- patible chemicals may damage the machine. Damages of this type arenot covered under the WINDSOR Three Year Protection Plan. Carefully read ingredients on manufac- turer’s label before using any product in this machine.
|
|
|
| I |
| I |
|
| |
|
|
|
| |
SUITABLE | INCOMPATIBLE | |||
CHEMICALS | CHEMICALS | |||
Alkalis | Aldehydes | |||
Defoaming Agents | Carbon Tetrachloride | |||
Detergents | Chlorinated Hydrocarbons | |||
Hydroxides | Methyls (MEK) | |||
|
|
| Perchlorethylene(per) | |
|
|
| Phenols | |
|
|
| Trichlorethylene | |
|
|
| ||
SAFETY/OPERATIONS
PREPARING FOR OPERATION(Cont..)
4.) Plug the power cords together and twist into locked position. Attatch the power cord to the yellow strain relief as shown. Plug power cord into a properly grounded wall outlet.
5.) Turn vacuum motor switch on and off to make sure there is electricalpower at machine.
OPERATING THE MACHINE
(PERFORMDAILYMAINTENANCEASSHOWN ON PAGE 7.)
1.Adjust the operator control handle to a comfortable position. (see item 3, page 6)
2.Switchon main power switch. (see item 1, page 5)
3.Release solution. (Pull solution control lever rearward.) (see item 6, page 6) NOTE: The amount of solution can be regulated during operation depending on the type of floor and the traverse speed of the machine. Pulling the lever farther rearward releases more solution.
4.Switch on brush drive motor. (see item 1, page 6)
5.Switch on vacuum motor. (see item 2, page 6)
6.Lower scrub deck. Pull scrub deck lift lever rearward. (see item 8, page 6)
is stationary.
7.Lower squeegee. Pull squeegee lift lever back. (see item 7, page 6) NOTE: Adjust squeegee as shown on page 9.
8.Move machine forward bv aDDlvinrr, . - - even pressureon the main haidle . Forward motion is assisted by the scrubbing action of the brushlpad driver.
Take extra care not to run machine over cord or catch cord on squeegee when turning.
7.Plan your cleaning route to work away from the electrical source. Move machine forward at a steady pace
TCPOE 98447 7/1/97 | 5 |
