Winegard MODEL CC-10HV Front of Antenna, Choosing a Location for the Antenna, Other Hardware

26 cm to nearest obstruction

4 Is within five degrees of level (for best operation, must be within three degrees of level)

• For sloped/rounded roofs, Winegard recommends model RW-2000 exterior roof wedge (sold separately) to level installation.

• An interior wedge, IW-5000 (sold separately), is also available.

Sold Separately

IW-5000

Sold Separately

RW-2000

Front of Antenna Mounting Bracket

Choosing a Location for the Antenna

Boom

Coax cable

Weather boot

Rotating gear housing

	Top View	Side View
	Leveling
	bracket
Upper
element		Base Plate	Bottom of
housing			gear housing
Base Plate	Rotating		Elevating
	gear housing		Shaft

Other Hardware

Directional Handle Ceiling Plate Decal

Lower element housing

Power Supply

	Nylon Bearing
Spring	Elevating
	Crank

Mounting bracket

Install in dry conditions only!

Before choosing a location for the antenna, contact your RV dealer or manufacturer. Your RV may be pre-wired or have a reinforced area for this system.

When choosing a location for the antenna, keep in mind that the antenna must be mounted on or parallel to the centerline of the coach with the front of the antenna (the mounting bracket) facing the front of the RV.

		Front of Antenna
The antenna is		Front
NOTE shown in the	Centerline of Coach	of
travel/stowed position.
		RV

Choose a location on the roof of the RV that meets the following requirements:

1Offers enough support for a secure installation

2	Has a minimum roof space (clearance) of 125.3 cm x 43.2 cm	43.2 cm
	for the stowed antenna
3	Allows antenna to raise and rotate without interference

Clearance Requirements

from other roof-mounted equipment
		125.3 cm
•	clearance distance of 61 cm from antenna to the front of the vehicle
•	clearance radius of 116 cm needed for antenna to raise to vertical position
•	clearance distance of 26 cm needed from antenna to nearest obstruction and to the edge of the roof

The Winegard Sensar HV antenna requires a minimum roof space of 125.3 cm x 43.2 cm for the stowed antenna.

When stowed, the top of
the element housing rests
11.2 cm above the roof.	115.6 cm

The antenna requires a clearance radius of 115.6 cm for the antenna to raise to the vertical position.

Maintain a minimum distance of 26 cm from the nearest obstruction and from the edge of the roof.

11.2 cm

125.3 cm

	26 cm to edge of roof
26 cm to nearest obstruction	61 cm to	Front
	front of RV
		of RV

1 Winegard Sensar HV Antenna Winegard Sensar HV Antenna 2