Approximately Degrees from Travel Position | Winegard RD-4610

CAUTION: After INITIAL	FIGURE 4
INSTALLATION,
the antenna SHOULD ROTATE
APPROXIMATELY 360
DEGREES FROM TRAVEL
POSITION.
The pointer on the
DIRECTIONAL HANDLE
should point towards the
ROTATION CLAMP when in
TRAVEL POSITION.

1 Ceiling Base

POINT TO

FRONT OF RV

POINTER MUST POINT TO CENTER OF ROTA- TION CLAMP WHEN IN TRAVEL POSITION

ASSEMBLED VIEW

3 Directional

Handle Extension

2 (4) #10 Phillips Flat

Head Screws

4 Directional

Handle

ALIGN POINTER

WITH ANTENNA

TRAVEL POSITION

5 ELEVATING CRANK HANDLE (When installed, extends 2-1/4" from ceiling). Snap Handle into base when not in use.

Rotation

Clamp

POINT TO

FRONT OF RV

Tighten screw snugly

6Rev 6/05/01

Image 6

Winegard RD-4610 owner manual Approximately Degrees from Travel Position, Directional Handle, Point to Front of RV

Contents

Install Point Base Toward Front Vehicle Winegard Installation & Assembly Antenna Shown Partially Raised For Ease of Illustration only Except for screw indicated in Figure Inside RV Travel Position Approximately Degrees from Travel PositionDirectional Handle Point to Front of RV Operation Elevation Lowering Antenna to Travel Position Tuning Antenna for Best PictureWatching OFF-AIR TV Position Except Travel Position DO’S VCR Mount Lubrication MaintenanceElevating Shaft & Worm Gear Assembly Replacement Procedure Lubricating Rubber Quad Ring Ordering Repair Parts Trouble Shooting No PictureWarranty Repair Work Antenna does not or is Hard to Rotate Parts List Rear View Not to Scale Parts List Interior Hardware KIT RK-CEIL Crank Handle KIT RK-HAND Specifications Model RP-4200 Thick Roof KIT Available Rev