Wizcom 2 Learning to Scan (using the Trainer)

Getting Started

Learning to Scan (using the Trainer)

This tutorial uses the Quicktionary application and the

plastic scanning Trainer provided with your Pen.

1. Slide the Trainer onto the tip of the Pen (instead of the

cap) and press into place.

2. Turn the Pen on. The Select Dictionary menu will

appear. Select the English Æ German dictionary.

3. The Input Screen will appear with the message “Scan

in English”. The red light flashing at the tip of the Pen

indicates that the Pen is ready to scan.

4. Position the Pen at a 90° angle and center the following

text between the feet of the trainer. This angle should

be maintained even when scanning without the trainer.

Use the following practice sentence:

5. Glide the Pen from right to left in a straight line over the

text. Start scanning 1cm from the end of the text and

finish 1cm after the beginning of the text.

6. The Split Screen will appear, with the scanned text on

the screen. If the text does not appear correctly on the

screen, scan again and the text on screen will be over-

written by the new text.