Wolf ICBIF15/S L F Fryer Module Manual Drain O U T L E T, Multiple Cooktop I N S TA L L AT I O N

W O L F FRYER MODULE

MANUAL DRAIN O U T L E T

IMPORTANT NOTE: The fryer module must be installed in a base cabinet that allows access to the manual drain valve for draining the oil. A heat-resistant bucket must be positioned under the drain outlet to accept the oil. The bucket must be able to hold 7.6 L. Refer to the Instal- lation Specifications illustration on

page 7 for location of the manual drain outlet.

MULTIPLE COOKTOP I N S TA L L AT I O N

IMPORTANT NOTE: If the fryer module is to be used with a combination of additional cooktop units or modules with a filler strip, the cut-out width is calculated by adding the corresponding units' cut-out dimensions plus 32 mm for each additional unit.

When multiple units are installed side by side, each unit must have its own separate recom- mended electrical circuit.

When two or more modules are installed together, an integrated module filler strip (IFILLER/S) is recommended. Contact your Wolf dealer for information on accessories.

IMPORTANT NOTE: Review specific installation instructions for product to product capabilities.

This fryer module must be installed at least 381 mm away from any open-flame cooking device. The open flame may cause ignition of oil.

This fryer module must be installed at least 381 mm away from a Wolf steamer module, as contact between water and hot oil may cause burns from steam and hot oil.

1518 mm FOUR MODULES WIDTH OR

1511 mm / 762 mm COOKTOP AND TWO MODULES OR

1276 mm / 914 mm COOKTOP AND ONE MODULE

1130 mm THREE MODULES WIDTH OR 1124 mm / 762 mm COOKTOP AND ONE MODULE

743 mm

TWO MODULES WIDTH

64mm min

356

mm

CUT-OUT

WIDTH

489

mm

CUT-OUT

DEPTH

FRONT OF COUNTERTOP

Countertop cut-out dimensions for installation of multiple cooktops

8