Alto-Shaam 4.10esi ventless hood model, operation, i n s t a l l a t i o n, filter door latch

i n s t a l l a t i o n

ventless hood model

The Ventless Hood option is factory installed
directly on the top of the Alto-Shaam Combitherm
oven. The hood is designed to vent clean air back
into the kitchen, filtering vapors and grease. A
high-power fan draws steam and fumes into the	2
hood intake and out the top surface exhaust vent.
Fumes and vapors are circulated through filters.
An activated charcoal filter cleans the air before	1
venting it out the top of the hood.

operation

1 Turn the ventless hood power knob “ON”. 3

2 Indicator light will illuminate.

3 Wait five seconds, then press the Combitherm oven power “ON”.

filter door latch

Using a coin or screwdriver, turn to open; reverse procedure to close and latch.

Hood and oven will not operate unless this is closed properly.

Indicator Light

If the indicator light does not illuminate, the filters may be missing or not properly aligned. Check them for proper positioning. Ventless hood and oven will not operate unless the hood is closed properly.

Timed Latching Mechanism: In order to evacuate steam and grease- laden air from the oven interior, this mechanism prevents the operator from fully opening the oven door for 20 seconds. Longer wait times can be programmed into the control. The mechanism automatically disengages at the end of a pre-set time allowing full door extension.

Emergency Latch Release: This release is to be used ONLY if the timed latch mechanism is not working or in the event of a power outage. Repeated use of the emergency release may damage the switching mechanism. Latch is located on the right side of the oven, toward the back.

CT Express INSTALLATION MANUAL • 17..