Alto-Shaam 4.10ESiVH danger, Positioning on site, Minimum Clearance Requirements, c a u t i o n

Models: 4.10esi 4.10ESiVH

1 28
Download 28 pages 36.07 Kb
Page 6
Image 6
Positioning on site

i n s t a l l a t i o n

site INSTALLATION

c a u t i o n

THE APPLIANCE MUST REMAIN ON

THE PALLET WHILE BEING MOVED

TO THE INSTALLATION SITE BY FORK

LIFT OR PALLET LIFT TRUCK.

NOTE: Note dimensions required for doorways and aisles for access of the oven and pallet to the installation site. Transport the oven in an upright and level position only. Do not tilt the oven.

NOTE: To avoid equipment damage, observe attention label on oven for area to avoid with lifting fork.

Positioning on site

Stand the oven in a level position. Use the adjustable feet to overcome an uneven floor and ensure that the unit is level.

It is strongly recommended that table top models be mounted on a factory supplied stand or a stand that is stable, open, and level. Recommended height is 32-inches (813mm). Air supply vents are located at the bottom of the oven and must not be blocked when mounted on a stand.

To insure proper operation, the installation of this oven must be completed by qualified technicians in accordance with the instructions provided in this manual. Failure to follow the instructions provided may result in damage to the oven, building, or cause personal injury to personnel.

 danger danger

DO NOT store or use gasoline or other flammable vapors or liquids in the vicinity of this or any other appliance.

c a u t i o n

TO PREVENT PERSONAL INJURY,

USE CAUTION WHEN MOVING OR

LEVELING THIS APPLIANCE.

MINIMUM CLEARANCE REQUIREMENTS

left side

4" (152mm) minimum

 

18" (457mm) service access recommended

 

20" (508mm) from heat producing equipment

right side

4" (102mm)

back

4" (102mm) for plumbing

bottom

4" (102mm) for air movement

top

20" (508mm) for air movement

NOTE: Additional clearance is needed for service access. A minimum distance of 18-inches is strongly recommended. If adequate service clearance is not provided, it will be necessary to disconnect the water and drain to move the oven with a fork lift for service access. Charges in connection with inadequate service access is not covered under warranty.

CT Express INSTALLATION MANUAL • 4..

Page 6
Image 6
Alto-Shaam 4.10ESiVH danger, Positioning on site, Minimum Clearance Requirements, c a u t i o n, i n s t a l l a t i o n