Wolf Pro Wall installation instructions Installation I N S T R U C T I O N S S TA L L Wiring

INSTALLATION I N S T R U C T I O N S

I N S TA L L WIRING

I N - L I N E O R R E M OT E B L OW E R W I R I N G

Remove the hood electrical box cover.

Run power cable to the installation location. Insert the power cable into the electrical box by running it through the wire clamp previously installed. Tighten the wire clamp to secure the cable.

Run the blower cable to the installation location. Insert the blower cable into the electrical box by running it through the other wire clamp previously installed. Tighten the wire clamp to secure the cable.

Cut off the butt crimp connector from the end of ORANGE wire in hood. Strip ORANGE wire about 3/8" (10). Using an appropriate wire connector (not included), connect BLACK wire from blower to ORANGE wire from hood. Using the supplied wire connectors, connect other wires as follows: BLACK wire from hood to power supply BLACK wire, all WHITE wires together and GREEN or BARE wires from power supply and blower to GREEN ground screws in the electrical box. Refer to the wiring diagram below.

Place all wiring connections inside the electrical box and reinstall the cover. Make sure that the wires are secure and that no wires are pinched between the cover and box.

Power cable

120 V

In-line or Remote blower cable

BLK

WHT

WHT

BLK

WHT

BLK

WHT

BLK

BLK
WHT		WHT
			BLK
WHT			HS
		THERMOSTAT
		3
		2	1
ORA	ORA
WHT	BRN
BLK	RED
BLK	BLU
BLK	BLK		L H
SPEED	SPEED		LIGHT
CONTROL
	CONTROL
			SWITCH
		BLK

		WHT	WHT
				only)
	WHT			(in 48" and 54" width
BLK	LIGHT SOCKET	LIGHT SOCKET
	YEL			OCKET
		YEL	YEL
				S
YEL				LIGHT
		COLOR CODE
	BLK	BLACK		RED	RED
	BLU	BLUE		WHT	WHITE

M M

Internal blower

BRN	BROWN	YEL	YELLOW
ORA	ORANGE

Wiring diagram
Dimensions in parentheses are in
millimeters unless otherwise specified.	13