INSTALLATION I N S T R U C T I O N S
ISLAND HOOD I N S TA L L AT I O N
M O U N T H O O D TO S U P P O RT F R A M E
Mount the hood to the support frame by aligning the four weld screws on the hood to the four holes on the support frame. Use four nuts to secure the hood to the support frame. Refer to the illustration below.
Nest the bottom of the telescopic chimney flue into the relief in the hood shell. Make electrical connections.
E L E C T R I C A L C O N N E C T I O N S
IMPORTANT NOTE: This ventilation hood must be properly grounded. This unit should be installed by a qualified electrician in accord- ance with all applicable national and local electrical codes.
Remove the cover from the rear electrical box. Remove the electrical box knockout that faces the hood's discharge collar.
Insert 6" (152) of 120 V AC power cable through the knockout opening. Secure the cable to the electrical box with an appropriate connector.
Make electrical connections. Connect black to black, white to white and green/yellow to green or bare wire. Refer to the illustration below.
Reinstall the electrical box cover and screws. Make sure that all wires are secure and that no wires are pinched between the cover and box.
Refer to page 13 for internal blower installation guidelines and remote blower wiring.
C O N N E C T D U C T W O R K
Use an 8" (203) round metal duct to connect the duct collar on the hood to the ductwork above. Use duct tape to make all joints secure and air tight.
Slide the lower telescopic chimney flue section downward until it fits properly around the hood shell.
I M P O RTA N T N OT E
You must follow all National Electrical Code regulations. In addition, be aware of local codes and ordinances when installing your service.
Decorative Flue
Support | Nuts | |
Frame | ||
|
Weld Screws on Hood
green/yellow to |
|
|
| ||
green or |
|
| black to | ||
bare wire | rear | black 120 V AC | |||
|
| power cable | |||
| electrical | ||||
|
|
| |||
| box |
|
|
| |
|
|
|
| ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
white | discharge |
to white | collar |
HOOD FRONT | TOP OF HOOD SHELL |
Mount island hood to support frame | Electrical connections |
Dimensions in parentheses are in |
|
millimeters unless otherwise specified. | 11 |
