Wolf Appliance Company 801640 14 11, 14 5, Wall Mount Installation, Wire The Ventilator, Model

MODEL 804701

WALL MOUNT INSTALLATION

Page 3

For use with Models CTWH30, CTWH36, IH4227, W30-662418, W30-662718, I36-663418,
L34-582212, DD30R, DD36R, DD45R.	WIRE THE VENTILATOR
PREPARE THE WALL
	4 Remove 10
	COVER SCREWS

	20"					and lift off
						ventilator cover.
						5 Feed the electric
						power cable	GROUND
	1¼" dia. hole					through the 1¼"	TO
							GROUNDING
						DIAMETER HOLE	SCREW
	Pilot Hole					and connect cable
				3"		to ventilator with a	WHITE
1411/16"	(centered between studs)					proper connector
							TO
						for the type of	BLUE
						cable being used.
						6 Connect BLACK
					29½"	TO BLACK,	120
						WHITE TO BLUE,
	Stud						VAC
						TO GROUNDING
							IN
						and GROUND	LINE
	Wall		Stud			SCREW.
							BLACK TO BLACK
	REMOVE	11" dia.	Wall
		hole				INSTALL THE VENTILATOR
	SIDING
	14 5/ 8"						Drill 6
						10 Cover	Mounting
							Holes
	25"					Screws

From inside the wall:

1 Drill a PILOT HOLE through the wall, centered between

WALL STUDS.

From outside - on the wall:		Flashing
2	Measure and mark the 25" x 29½" rectangle. Cut and remove
		Sheet
	only the siding inside this rectangle.

3 Measure and mark the 11" DIAMETER HOLE and the 1¼"
DIAMETER HOLE. Cut these holes all the way through the
wall.	Damper

Bird Screen

OUTSIDE - WALLROOF VIEW

7 Place ventilator on wall so that ventilator's discharge collar fits into 11" diameter hole.

8 Use the 6 screws (provided) to attach the ventilator to the wall. DRILL 6 MOUNTING HOLES inside the ventilator, as necessary.

9 Seal the screw heads and edges of the flashing sheet with a good grade of roofing cement.

10 Check for free movement of the spring-loaded DAMPER and re-install ventilator cover. Turn on power and check operation.