ASSEMBLY
Tools Required
•Adjustable Wrench
•#2 Phillips Screwdriver
Assemble Drill Press Stand
WARNING Do not attempt to use your Universal Drill Press
Stand unless it is fastened firmly to your workbench or floor. Failure to do so may result in serious injury.
G (1) | H (1) |
M (1) | N (1) |
P (1) |
|
1.Secure base (A) to a solid object such as a workbench or a clamped- down board. Four holes are provided in the base for mounting (hardware not included).
2.Insert post (B) into base. Make sure plastic cap is on top. Install and tighten base bolt (G) securely. See Figure 1.
Plastic Cap
B 
G 
A
Figure 1
3.Assemble adjustment handle (D) to head assembly (C) with square nut (H). Place square nut in recess in back of head assembly. Insert adjustment handle through head assembly and thread it into square nut three full turns. See Figure 2.
D
C
H
Figure 2
4.Assemble depth stop by sliding depth stop collar (J) onto the depth stop carriage (K) from the bottom with the round side of the collar matching the round side of the carriage. Secure the collar by screwing the depth stop adjustment knob (L) in the threaded hole. See Figure 3.
K 
J
L 
Figure 3
7
