The electrical outlets on the bottom of the switch box accept three-prong grounded plugs and the two-prong plugs of double insulated tools.

If a correctly grounded outlet is unavailable, use a temporary adapter to connect the switch box’s three-prong plug to a two-hole receptacle. Make use of the temporary adapter only until a qualified electrician installs a correctly grounded, three-prong out- let. The green rigid lug or grounding wire MUST connect to the ground on the outlet. (See Figure 11.)

Figure 11

DO NOT plug the router in at WARNING this time. An ON switch will

start and an unprepared user could possibly be seriously injured.

The Switch Box also features a Safety Key (Y) that prevents the router’s ON/OFF switch from being turned ON inadvertently. Removal of the safety key disables the switch box by locking the switch in the OFF position. Strike the switch paddle with your hand to turn the router OFF in an emergency situation. Please note paddle switch positions and reset button

(NN)at this time.

Figure 12

WOLF113-14

RISK OF ELECTRIC SHOCK. WARNING DO NOT touch prongs when

inser ting or removing plug from outlet. Improper grounding can produce potentially hazardous electrical discharges that can, in turn, cause serious injury or death – especially in wet conditions, such as a basement, out- side, or near plumbing.

DO NOT attach a 3-way plug or WARNING any other adapter to outlets on

bottom of switch box.

Only use the switch box when it WARNING is properly assembled to the

router table AND when the router is properly attached to the router table.

Switch Box Familiarization (Figure 12)

The purpose of this section is to familiarize the user with the operation of the switch box BEFORE the router is plugged in.

OUTLETS

 

 

PULL

ON

 

 

 

PUSH OFF

 

RESET

 

 

 

NN

Y

 

WOLF113-11

Operation of Switch Box and Router

Make sure router switch is OFF WARNING and switch box is OFF BE-

FORE proceeding.

1.Insert the safety key.

2.Place router power switch to ON.

NOTE: If your router requires the use of the switch trigger and “LOCK-ON” button, refer to your Router Owner’s Manual for operating instructions.

3.Insert finger under paddle and pull switch to ON position.

4.To turn router OFF push paddle down.

Router bit must come to a com- WARNING plete stop before leaving router

table unattended.

10