Figure 9

DREMEL ®

NO

OFF

WOLF113-24

1.Attach the Dremel® Rotary Hobby Tool to the Tool Holder Assembly from the Dremel #330 Router Attachment Kit as stated in the Router Attachment Kit Owner’s Manual. See Figure 9.

2.Secure the hobby tool assembly to the router table using the Bracket Mounting Screws from the #330 Router Attachment Kit.

3.The solid insert that comes with this router table can be drilled out off center to give you better small workpiece support.

Switch Box

Introduction

A conveniently located Switch Box allows the operator to:

•turn the router ON and OFF from the front of the table

•simultaneously operate other devices

such as a light or a vacuum

It also features a resettable, internal circuit breaker (NN, Figure 12) that protects your equipment against overloads.

Electrical Hookup

Proper grounding diverts potentially dangerous electricity away from the operator. The switch box is intended for use with a three- prong, grounded outlet. (See Figure 10.) The switch box’s electrical cord features an equipment -grounding connector and a grounding plug. Insert the plug into an accommodating outlet that conforms to all local electrical codes and the National Electric Code (NEC).

DO NOT modify the plug. If it WARNING does not fit correctly, a qualified

electrician must install a compatible outlet.

Avoid the risk of electrical WARNING shock. NEVER connect the

equipment grounding connector (green wire) to a “hot” electrical terminal. When repairing or replacing the electric plug or cord, DO NOT connect the grounding connector to a “hot” electrical terminal.

Figure 10

WOLF108-13

Consult a qualified electrician if you do not understand the grounding procedures, or if you are not sure whether the switch box is correctly grounded.

Damaged and/or worn cords must be repaired or replaced immediately.

Extension cords must be three-wire, 14 gauge or larger, with three-prong “male” plugs, and three hole “female” receptacles fabricated to accept the tool’s plug.

9