NOTE: If your router does not fit adaptor base plate or if you wish to mount router directly to the table for greater cutting depth, remove the router base plate, use it as a template and drill directly through table top. Then, countersink the holes and fasten router to the table top, as described in Attaching Routers With Three Hole Pattern “E.”

3.Place the adaptor base plate on the router base as previously determined. See Figure 7.

4.Use the screws removed from the router base plate to attach the adaptor base plate to the router base. Tighten screws securely.

(The adaptor base plate comes from the factory with mounting nuts pressed into it.) See Figure 7.

Figure 8

F

CAUTION

Make sure the screws from

PU

LL

ON

OFF

SH

PU

T

SE

RE

 

your router base plate match

the countersink in the adaptor base plate and are long enough to mount adaptor base plate securely. Replace if necessary.

Figure 7

HH

I

W

 

TL

ET

S

OU

 

 

 

 

WOLF113-10

5.Mount the router with adaptor base plate using the #10-32 x 1/2" long flat head machine screws (HH) through holes in table top and router base and then into the mounting nuts (W). Tighten securely.

WOLF113-28

Mounting a Dremel® * Rotary Hobby Tool (Not Included)

Extend the capabilities of your Dremel Tool by mounting it to the router table as follows: (Dremel Tool and Dremel #330 Router Attachment Kit not included):

NOTE: To mount your Dremel Tool, the Dremel #330 Router Attachment Kit must be purchased separately.

*Dremel is a registered trademark of the S-B Power Tool Company.

8