Woods Equipment 2104045 Mount Installation, Attach Right and Left loader Mounts

Attach Right and Left loader Mounts

1.Attach right loader mount (1) to tractor frame using two cap screws (10) and hardened flat washers (12) in the forward top holes.

2.Insert cap screw (11) and hardened flat washer

(12)in the third and fourth hole.

3.Insert flange head cap screw (7) into the three holes in tractor clutch housing. Use cap screw (6) and washer (8) in the top rear slots to connect loader mount to tractor frame. For three lower slots, use hex flange screw (7) and hex flange nut

(9).

4.Repeat step to install left rear mount (2). Note: only 2 of item (6) are used on left mount.

5.Place center plate (3) between right and left mounts and secure using four (two per side) cap screws (10), hardened flat washers (12) and hex nuts (13).

6.Torque hardware to:

M14 x 1.5P x 40 mm . . . . . . . 87 lbs-ft (118 N-m) M14 x 1.5P x 50 mm . . . . . . . 87 lbs-ft (118 N-m) M12 x 1.75P x 35 mm . . . . . . . 70 lbs-ft (84 N-m) M12 x 1.25P x 30 mm . . . . . . . 55 lbs-ft (75 N-m)

1.1030978 Right mount

2.1030979 Left mount

3.1030986 Center plate

6.65505 12 mm-1.25P x 30 mm HHCS

7.1028293 M12-1.75x35 CL10.9 Hex flange screw

8.52177 .488 x 1.25 x .134 washer

9.1028338 M12-1.75 CL10 Hex flange nut

10.64127 M14 x 1.5P x 40 mm HHCS

11.65541 M14 x 1.5P x 50 mm

HHCS

12.46070 9/16 Hardened Flat Washer

13.43104 M14 x 1.5 Hex Nut

	12	11
		10
		12
	10
Tractor	12
Hardware	13
DP0001

Figure 2. Right Mount Installed

Figure 3. 2104045 Mount Kit Installation

4 Mount Installation

(Rev. 4/25/2011)

MAN0807 (6/17/2009)