Woods Equipment 59HC-1 manual Parts, Spindle Assembly

SPINDLE ASSEMBLY

REF	PART	QTY	DESCRIPTION
1	4116	1	Spindle
2	5089	2	Seal
3	4114	1	Sleeve
4	4115	1	Pin
5	4107	2	Bearing cone
6	4117	1	Housing with cups
7	4106	2	Bearing cup
8	1972	1	Grease fitting
9	4105	1	Spindle shaft
10	4110	1	Shoulder washer
11	12170KT	1	16-13/16 Medium suction
			blade (std for RM48) -or-
11	26548KT	1	16-13/16 Low suction blade
			(optional for RM48) -or-
11	6950KT	1	20-1/4 Medium suction blade
			(std for 59) -or-
11	26559KT	1	20-1/4 Low suction blade
			(optional for 59)
12	10658	1	5/8 NC x 1-1/2 Nylok bolt
13	3490	1	Blade bolt wrench (used prior
			to 1964)
14	2974	1	Spindle lock wrench
16	10635	2	5/8 Cup washer
17	692	1	5/8 Flat washer
18	1015825	1	Blade bolt and washers com-
			plete (not shown)

NOTE: When difficulty is experienced with a mower spindle, time and trouble will be saved by buying a complete new assembly.

*For maximum suction for difficult mowing.

**For use in sandy areas or where high abrasive wear occurs on fin of standard blade.

NOTE: Repair shaft (9) and repair sleeve (3) do not have a hole drilled in them for pin (4). After new parts have been assembled and proper bearing adjustment obtained, drill a 3/16 diameter hole through sleeve and shaft. Drive in Sel-lock pin to hold proper bearing adjustment.

18 Parts 29931 (Rev. 6/29/2007)