Service Cont’d
Replace Vacuum Spindle Bearings
1.Remove vacuum housing from deck.
2.Remove bearing mount (41) from Deck. Leave plastic coupler sleeve (43) attached to right deck spindle.
3.Remove spindle assembly (20) from bearing mount.
4.Remove cap screw (19) and cup washer (18) from top of spindle.
5.Remove sheave (16) from spindle shaft (14). A puller maybe required to remove sheave.
6.Press spindle shaft (14) through bearings (51) and out of spindle housing (15).
7.Press bearings (51) from spindle housing.
39
19
18
16 
51
15 |
| 20 |
|
10
Install New Bearings
1. | Press new bearings (51) in spindle housing. |
| Make sure spacer (10) is installed between |
| bearings. |
2. | Reverse steps 1 - 6 and reassemble spindle |
| housing. Make sure all hardware is installed |
| correctly. See page |
3. | Install bearing mount to deck. See ‘Install Bearing |
| Mount” on page 7. |
51
14
43
41
4. Attach vacuum housing to deck and secure. |
CD004
Figure 11. Vacuum Drive Spindle Assembly
10 Service | MAN0116 (Rev. 4/15/2004) |
|
