43 |
| 41 | |
|
19
44
56
45
46
57
CD002
Figure 6. Bearing Mount Assembly Installation
Install Vacuum Drive Belt
1.Install belt (37) over sheaves and idler as shown in Figure 7.
2.Engage belt tension lever (29) as shown in Figure 8.
Remove Vacuum Drive Belt
1.Disengage belt tension lever (29).
2.Release rubber latch on vacuum drive shield (39), Figure 9.
3.Remove belt shield (38) from vacuum housing (38), Figure 9.
4.Remove belt from sheaves and idler.
29
Figure 8. Belt Tension Lever Engaged
Install Belt Shield
NOTE: Check that belt is aligned and parts are installed properly. Test run vacuum housing and bear- ing mount for proper operation.
1.Install belt shield (38) on vacuum housing using three 5/16 x 1 cap screws, lock washers, and hex nuts.
2.Close vacuum drive shield (39) and secure with rubber draw latch.
3.Make sure belt tension lever is engaged.
38
39
Figure 9. Belt Shield Installed (D5221T Shown)
Figure 7. Drive Belt Installation
MAN0116 (Rev. 4/15/2004) | Installation 7 |
| |
|
|
