4.Rotate vacuum housing assembly into place so that the clevis shaft on vacuum housing assembly slips inside vacuum front mount (38).
5.Install lynch pin (62) to lock the housing into place.
NOTE: If necessary, adjust the position of the vacuum front mount to allow for easy installation of lynch pin.
6.Tighten hardware.
Remove Vacuum Housing
1.Remove lynch pin (62).
2.Rotate vacuum housing assembly away from vacuum front mount (38).
3.Lift vacuum housing assembly from vacuum mount (35).
ATTACH DISCHARGE CHUTE
Be sure either the discharge chute, mulching end cap, or complete vacuum attachment is installed and in good condition. Replace if dam- aged.
1.Remove vacuum housing from deck.
2.Install chute adapter with discharge chute attached.
3.Insert the pivot shaft of chute adapter (59) into sleeve of vacuum mount (35).
4.Rotate the chute adapter in place so that the clevis shaft on chute adapter slips inside vacuum front mount (38).
5.Install the lynch pin (62), to lock the chute adapter into place.
62
DP1
Figure 4. Discharge Chute with Adapter Installed
INSTALL BEARING MOUNT ASSEMBLY
Remove Hardware
1.Remove center and right belt shield.
2.Remove top bolt (A), cupped washer (B), and spacer from the right spindle assembly.
A
B
DP2
Figure 5. Right Spindle and Sheave Assembly
Install Bearing Mount
Refer to Figure 6.
1.Install washer (49) and lower coupler drive (39) over right spindle sheave.
2.Align keyway of sheave and flex coupler and install
.25 x .069" square key (40) that comes with kit.
3.Secure sheave and flex coupler to spindle shaft using sheave bolt (41) and flat washer (9).
4.Place nylon flex coupler sleeve (42) over lower flex coupler drive (39) and align grooves.
5.Install vacuum drive mount (43) by positioning the drive spindle assembly into the nylon flex coupler sleeve (42).
8 Installation | MAN0258 (Rev. 12/14/2007) |
|
|
