![](/images/new-backgrounds/1095306/9530645x1.webp)
Model: H
Install Hydraulic Cylinders
Refer to Figure 22.
1.Place hydraulic angle arm (1) on boom as shown.
2.Secure into position using three cap screws (33), lock washers (35), and flat washers (34).
3.Attach hydraulic angle cylinder (5) to boom and hydraulic angle arm assembly as shown. Secure with pins supplied with the cylinder.
4.Attach hydraulic offset cylinder (5) to
5.Attach hydraulic tilt cylinder (4) to pivot assembly and blade as shown. Secure with pins supplied with the cylinder.
6.Install two adjustable elbows (6) to each of the hydraulic cylinders as shown.
7.Install two hoses (15) to the hydraulic tilt cylinder.
NOTE: Do not install angle and offset cylinders hoses at this time.
8.Attach hose holder (9) to back side of
|
|
| 9 | 6 |
| Offset |
1. | Hyd Angle Arm Assembly | 28 | 29 | 5 |
|
|
4. | Cylinder, Hyd |
|
| |||
|
|
| ||||
5. | Cylinder, Hyd |
| 30 |
| 33 |
|
6. | Elbow, 3/4 ORBM 3/4 JICM 90 |
|
|
|
| |
9. | Hyd Hose Holder |
|
|
| 35 | 1 |
15. | Hose, 3/8 138 1/2 NPTM 3/4 JICF |
|
|
| 34 | |
|
|
|
| |||
|
|
|
|
| ||
28. | Bolt, Carriage 3/8 NC x |
|
|
|
|
|
29. | Washer, 3/8 Flat |
|
|
|
|
|
30. | Nut, Lock 3/8 NC |
|
|
|
|
|
33. | Screw, HHCS 3/4 NC x 3 GR5 |
|
|
|
|
|
34. | Washer, Flat 3/4 SAE |
| 6 |
|
|
|
35. | Washer, Lock 3/4 |
|
|
|
| |
|
|
|
|
|
| |
| Angle |
|
|
|
|
|
| 5 |
|
|
|
| 15 |
|
|
| 4 |
|
| 6 |
|
|
|
| Tilt | ||
|
|
|
|
|
Figure 22. Hydraulic Cylinder Installation
MAN0160 (Rev. 2/22/2006) | Assembly 23 |
| |
|
|