![](/images/new-backgrounds/1095306/9530623x1.webp)
To angle the blade:
1.Raise blade a few inches above the ground by operating the lift control lever of the tractor.
2.Actuate the control valve to which the swing cylinder is connected.
3.On tractors having two circuit selector valves, select swing circuit and actuate tractor control valve connected to selector valve.
NOTE: Do not operate the selector valve under load.
4. Hyd Cylinder 3.5 x 1.25 x 8 |
|
5. Hyd Cylinder 3.5 x 1.5 x 16 |
|
| 5 |
| Swing |
| 1 |
Angle | |
| |
5 |
|
4 | Tilt |
| |
Figure 7. Hydraulic Configuration - Offset | |
OPERATING TIPS |
|
Look down and to the rear and make sure area is clear before operating in reverse.
Do not operate on steep slopes.
Do not stop, start, or change directions sud- denly on slopes.
Use extreme care and reduce ground speed on slopes and rough terrain.
Watch for hidden hazards on the terrain during operation.
Before working underneath, read manual instructions, securely block up, and check stability. Secure blocking prevents equipment from drop- ping due to hydraulic leak down, hydraulic system failure, or mechanical component failure.
CAUTION
Stop power unit and equipment immediately upon striking an obstruction. Turn off engine, remove key, inspect, and repair any damage before resuming operation.
BACKFILLING
For backfilling ditches or trenches, reverse the blade by rotating
LEVELING AND GRADING
Set the blade to the desired position of offset, angle and tilt for leveling and grading.
PRE-OPERATION CHECK LIST
(OPERATOR’S RESPONSIBILITY)
___ | Review and follow all safety rules and safety |
| decal instructions on pages 5 through 8. |
___ | Check that equipment is properly and securely |
| attached to tractor. |
___ | Check that all safety decals are installed and in |
| good condition. Replace if damaged |
___ | Check that all hardware and cotter pins are prop- |
| erly installed and secured. |
___ | Check that all lubrication points are greased. |
___ | Check that blade cutting edge is in good condi- |
| tion. |
___ | Check that all hydraulic hoses and fittings are in |
| good condition and not leaking before starting |
| tractor. Check that hoses are not twisted, bent |
| sharply, kinked, frayed or pulled tight. Replace |
| any damaged hoses immediately. |
12 Operation | MAN0160 (Rev. 2/22/2006) |
|
|