Woods Equipment RB850-4 Optional Equipment ALL Models, Install Pneumatic Tailwheel 28775 Optional

OPTIONAL EQUIPMENT - ALL MODELS

Install Pneumatic Tailwheel 28775 (Optional)

IMPORTANT

■When grading with tailwheel attached, do not attach upper link of tractor 3-point hitch to blade without using floating links (2 & 3). Without float- ing links, equipment damage may result and void warranty.

Refer to Figure 30.

The tailwheel is very helpful for finish grading and lev- eling work. The ratchet controls the approximate cut- ting height.

1.Remove top link of tractor 3-point hitch.

NOTE: Do not use with Category 2 quick-attach cou- plers.

3.Secure into position with top link pin.

4.Attach bracket (9) to boom assembly with clevis pin (10), two flat washers (12) and two cotter pins (13). Secure together with cap screw (14).

5.Attach tailwheel arm (15) and yoke (24) to bracket

(9) with clevis pin (11), washers (26), and cotter pin (13).

6.Attach ratchet (8) between bracket (9) and tail- wheel arm (15). Secure with pins supplied with ratchet.

2.Attach float links (2 & 3) and sleeve (4) to inside of the top holes of A-Frame. 3/4 dia. welded pin on side of float links must face outward and be located on the bottom end.

7.Attach top link to float links (2 & 3) using clevis pin (5), two SAE flat washers (6), and cotter pins (7).

1

			14.	Cap Screw, 1/2 NC x
				1-3/4 GR5
			15.	Tailwheel Arm Asy
			16.	Cap, Dust
2.	Link, Floating Right		17.	O-Ring .09 x 1.56 OD
			18.	Bushing, Bronze 1.5
3.	Link,	Floating Left
				x 1.63 x 1.50
4.	Sleeve,	1.00 x 1.25 x 1.44	19.	Grease Fitting,	1/4-28
5.	Pin, Clevis 1 x 4-29/32 HT			Tapered Thread
6.	Washer, Flat 1” SAE		20.	Grease Fitting,	1/8
7.	Pin, Cotter 1/4 x 2-1/4			Pipe Thread
8.	Ratchet		21.	Plate, Top Dampener
9.	Tailwheel Bracket Asy		22.	Disc, Friction 4 x 6.15
10.	Pin, Clevis 3/4 x 12-1/4		23.	Pin, Spirol
11.	Pin, Clevis 1 x 12-1/4			7/16 x 2-1/2
12.	Washer, Flat 3/4 Standard		24.	Wheel Yoke Asy
13.	Pin, Cotter 1/4 x 1-1/2		26.	Washer, Flat 1” Std

Figure 30. Pneumatic Tailwheel Installation

MAN0160 (Rev. 2/22/2006) Assembly 27