OPERATION
The Woods Flail Shredder is designed to pick up and shred crop and plant residue left in the field. Rotational power to the flails is provided by the tractor PTO.
Be familiar with the flail shredder before starting.
The owner is responsible for training operators in the safe operation of the flail shredder.
Safety instructions are important! Read all attachment and power unit manuals; follow all safety rules and safety decal information. (Replace- ment manuals and safety decals are available from your dealer. To locate your nearest dealer, check the Dealer Locator at www.WoodsEquipment.com, or in the United States and Canada call
Never allow children or untrained persons to operate equipment.
Make sure shields and guards are properly installed and in good condition. Replace if damaged.
Keep hands, feet, hair, and clothing away from equipment while engine is running. Stay clear of all moving parts.
Never allow riders on power unit or attachment.
Before dismounting power unit or performing any service or maintenance, follow these steps: disengage power to equipment, lower the
Do not allow bystanders in the area when oper- ating, attaching, removing, assembling, or servic- ing equipment.
Keep bystanders away from equipment.
Operate tractor PTO at the rpm speed stated in “Specifications” section.
CAUTION
Always sit in power unit seat when operating controls or starting engine. Securely fasten seat belt, place transmission in neutral, engage brake,
and ensure all other controls are disengaged before starting power unit engine.
CAUTION
Always comply with all state and local lighting and marking requirements.
Always wear relatively tight and belted clothing to avoid getting caught in moving parts. Wear sturdy,
PRINCIPAL COMPONENTS
The Woods Flail Shredder consists of a large rotating tube with swinging steel flails attached. The flails pick up or strike crop residue or trash and shred it. Rota- tional power to the drum is provided by the tractor PTO through a gearbox in the center of the machine.
For removing the center strip of crop residue, an optional hydraulically driven blade can be installed under the cover in the center of the machine.
The flail shredder is designed to be used as a semi- mounted, or
BREAK-IN OF THE FLAIL SHREDDER
The following should be observed when operating the unit for the first time:
After operating for 1/2 hour
1.Check all nuts, bolts, and other fasteners. Tighten to specifications given in the Bolt Torque Chart, page 59.
2.Tighten wheel bolts to specifications given in the Bolt Torque Chart, page 59.
3.Check that the flails are in good condition and swing freely.
4.Check oil level in the gearbox. Add oil if needed.
5.Check that the PTO driveline shield turns freely.
6.Lubricate all grease points.
After operating for 5 to 10 hours
1.Repeat Steps 1 through 5 above.
2.Follow regular service schedule as outlined in Lubrication Schedule, page 24.
14 Operation | MAN0943 (07/12/2011) |
|
|
