Auger Drive Shear Bolt Replacement
■Always use approved shear bolt as replace- ment part. Using a hardened bolt or shear pin may result in damage to driveline or gearbox.
Remove any obstructions from the auger, chain, or drive sprocket.
Remove auger drive shield (1) by removing 3/8 NC Whiz Nuts (3).
Remove damaged bolt from shear plates on auger drive sprocket (5) and/or auger drive shaft (4).
Rotate drive sprocket to align holes in sprocket and shaft. Install new shear bolt and secure with lock nut. Tighten to torque specification given on Torque Chart.
1.Auger Drive Shield
3.3/8 NC Whiz Nut
4.Auger Drive Shaft
5.Auger Drive Sprocket
Figure 11. Auger Drive Shear Bolt Replacement
Discharge Chute Lubrication
1.Apply grease between the discharge chute base and ring on the frame tube, Figure 12, annually.
PIC3
Figure 12. Chute Base and Rotator Ring
Gearbox
The gearbox is almost
WARNING
■Before proceeding, read and follow all safety rules.
To change the oil, follow this procedure, Figure 13:
1.Suction out oil in gearbox through side plug using a hand pump.
NOTE: It is best to drain the oil when the gearbox is warm to remove the most contaminants.
2.Add 1.27 quart SAE 85W90 gear oil through side plug. Use level hole (halfway up the backside of gearbox) to check oil level. Add oil accordingly.
3.Install and tighten plug.
Figure 13. Gearbox Oil
MAN0884 (08/15/2011) | Owner Service 19 |
|
|