Model D3274 Gravity Feed Spray Gun w/Regulator
OPERATIONS
EXPLOSION HAZARD! DO NOT smoke or have any source of flame or spark near spraying. Vapors will explode if ignited.
RESPIRATORY HAZARD! Always use respirator rated for organic vapor and solvent use when using spray equipment. Failure to protect your lungs can lead to respiratory illness and nervous system damage.
TOXIC FUMES! Always use an approved spray booth or well ventilated area when spraying. NEVER spray in an confined space where toxic fumes and flammable vapors can accumulate to deadly levels.
Spraying
The Model D3274 HVLP (high volume, low pressure) spray gun set is designed to spray a wide variety of materials like lacquers, stains, primers, multi- component paints, clear coats, acrylics, epoxies etc. It is ideal for auto body and woodworking projects.
To use your spray gun:
1.Read and follow the material manufacturer's instructions for spraying, reducing, safety, disposal, and any other instruction on the label or Material Safety Data Sheet (MSDS).
2.Ensure the cup is securely tightened and all other fittings are secure to avoid air leaks or material spills.
3.Use the regulator control (Figure 3), to set the inlet air pressure to 30 PSI or to the material manufacturer's recommendations (not to exceed 70 PSI).
4.Adjust the atomizing cap (Figure
3) for a vertical or horizontal spray pattern. Refer to Atomizing Cap and Fan Adjustments on Page 9 for further explanation.
5.After the material has been reduced to the manufacturer's specifications, fill the cup with the thinned material.
6. Trial and error, along with a fair amount of practice are necessary to achieve the results you want. Test your material flow and spray pattern on a piece of cardboard or some scrap of material similar to your project.
