Woodstock d4327/d4328 instruction sheet

Introduction

Your new Model D4327/D4328 Quick Release Wood Vise

(Figure 1) is designed to fit on workbenches 21⁄4" and

thicker, but can be adapted to workbenches down to 11⁄2"

thick by using a shim. Holes are pre-drilled in the jaw

faces to attach aftermarket or shop-built wood clamping

vise jaw pads.

D4327 Specifications

• Jaw Width .................................................7"

• Mounting Height (Workbench Thickness) ..........21⁄4"

• Maximum Jaw Opening ..................................8"

• Weight ................................................21 lbs.

D4328 Specifications

• Jaw Width .................................................9"

• Mounting Height (Workbench Thickness) ..........21⁄4"

• Maximum Jaw Opening ................................ 10"

• Weight ................................................25 lbs.

Installation

1. Have another person hold the vise up against the

workbench in the desired mounting location. If the

workbench has holes for bench dogs, make sure the

bench dog on the vise is aligned with those holes.

Note: If the workbench is less than 21⁄4" thick, use a

piece of scrap wood (Figure 2) between the vise and

workbench as a shim. Cut the shim to the necessary

thickness so the vise does not protrude above the

workbench after mounting.

2. Pencil mark the workbench through the mounting

holes to establish locations to drill pilot holes.

3. Use a 1⁄8" drill bit to drill pilot holes approximately

11⁄2" deep in the face of the workbench, where the

wood screws will be used (see Figure 3).

Model D4327/D4328Quick Release Wood Vise

Instruction Sheet

Phone #: (360) 734-3482 • Online Tech Support: tech-support@shopfox.biz • Web: www.shopfox.biz

Figure 3. Mounting hole locations.

Mounting Holes

for Wood

Screws

Mounting

Holes for Lag

Screws

Vise

Workbench

Shim

Figure 2. Shim placed between workbench

and vise for workbenches under 21⁄4".

Figure 1. Quick release wood vise.

WARNING: NO PORTION OF THIS MANUAL MAY BE REPRODUCED IN ANY SHAPE OR FORM WITHOUT

THE WRITTEN APPROVAL OF WOODSTOCK INTERNATIONAL, INC. Printed in China#14922ST