Woodstock Electrical, 110V Operation W1685, 220V Operation W1666, Extension Cords, Grounding

W1666, W1685 Dust Collectors

ELECTRICAL

110V Operation (W1685)

ELECTRICAL

The Model W1685 11/2 HP dust collector operates at 110 volts only, and draws up to 16 amps.

Make sure that the power supply circuit this machine is connected to meets local and federal electrical code requirements. Seek assistance from a qualified electri- cian if you are unsure about electrical codes and wiring!

220V Operation (W1666)

The Model W1666 2 HP dust collector operates at 220V only, and draws up to 12 amps. Connect a 220V 6-15 plug and outlet for your power connection (see Figure 7).

Make sure that the power supply circuit this machine is connected to meets local and federal electrical code requirements. Seek assistance from a qualified electri- cian if you are unsure about electrical codes and wiring!

Extension Cords

When it is necessary to use an extension cord, use the following guidelines:

•Use cords rated for standard service.

•Use cords under 50 feet of length.

•Use cords with 14 ga. wire or bigger.

•Ensure cord has a ground wire and pin.

Grounding

This machine must be grounded! The plug attached to the electrical cord supplied with this machine comes with a grounding pin. Do not remove it. If your outlet does not accommodate a ground pin, have it replaced by a qualified electrician or have an appropriate adapter installed.

Note: When using an adapter, the adapter must be grounded.

DO NOT attempt to work on your elec- trical system if you are unsure about electrical codes and wiring! Seek assistance from a qualified electri- cian. Ignoring this warning can cause electrocution!

This equipment must be grounded. Under no circumstances should the grounding pin from any three-pronged plug be removed or electrocution may occur.

6-15P6-15R

Figure 7. A 220V 6-15 plug and outlet.

-11-