M1051 6" Bench Grinder
Test Run
Once your machine is mounted and assembled, you should perform a test run to make sure it works properly.
To perform a test run, do these steps:
1.Make sure all tools are removed from the grinder area.
2.Make sure the switch is in the OFF position.
3.Plug the grinder into the power source.
4.Move the switch to the ON position.
•Under normal conditions, the grinder will make a loud humming noise, with only minor vibration.
•If you hear or see anything unusual with the grinder, turn it OFF, unplug it, and troubleshoot the cause the problem. If you CANNOT determine the source of the problem, call our tech support BEFORE starting the machine again.
SET UP
DO NOT investigate problems or adjust the bench grinder while it is running. Wait until the machine is turned OFF, unplugged and the spindle has come to a complete stop before proceed- ing!
