M1107 Bench grinder
Test Run
SET UP
Once your machine is mounted and assembled, you should perform a test run to make sure it works properly.
To perform a test run, do these steps:
1.Make sure all tools are removed from the grinder area.
2.Make sure the switch is in the OFF position.
3.Plug the grinder into the power source.
4.Turn the grinder ON. Under normal conditions, the grinder will make a humming noise, with only minor vibration.
—If you suspect any problems, immediately turn the grinder OFF and refer to Page 15 to trouble- shoot and correct any problems before starting the grinder again.
—If the source of an unusual noise or vibration is not readily apparent, contact our technical support for help at (360)
DO NOT investigate problems or adjust the bench grinder while it is running. Wait until the machine is turned OFF, unplugged and the spindle has come to a complete stop before proceed- ing!
