Table Tilt
To adjust the working table angle:
1.Set the working table angle to the 90° mark on the scale.
2.Using a 90° square, adjust the working table so it is perpendicular to the sanding disc as shown in Figure 29.
3.Loosen the screw holding the angle indicator and set it to the 90° mark on the scale.
4.Using a 90° square, check to see if the miter slot is perpendicular to the sanding disc as shown in Figure 30.
5.To adjust, loosen the three screws shown in Figure 31. Wiggle the table until the miter slot is parallel to the sanding disc and tight- en the adjustment screws.
Make sure the gap between the working table edge and the sanding disc is no larger than 1⁄8". Your fingers could get caught in the gap, causing serious personal injury.
