Working Table
The working table has two mounting locations: next to the sanding disc and next to the verti- cally positioned belt sander. We recommend ini- tially mounting the working table next to the disc. If you want to mount it next to the verti- cally positioned belt sander, skip to the “Vertical Positioning” instructions in the Adjustment section.
To install the working table next to the disc:
1.Loosen the (2)
2.Insert the support bar into the hole in the base that is adjacent to the setscrew holes. Make sure that the flat side of the support bar is facing the setscrews.
3.Securely tighten the setscrews as shown in
Figure 15.
4.Slide the working table assembly onto the end of the support bar and securely tighten the setscrews located in the table support bracket as shown in Figure 16. Be sure to leave no more than a 1⁄16" gap between the disc and the edge of the working table.
Quick Release
The quick release lever is used to loosen the tension on the sanding belt. To install the quick release lever:
1.Thread a
2.Thread the ends of the levers into the threaded holes in the short lever and the rocker arm.
3.Finally, position the levers as shown in Figure 17 and tighten down the hex nuts.
