Woodstock W1668 manual Table insert

OPERATIONS

		W1668 131⁄4" Oscillating Drill Press
7. Remove the mandrel nut from the mandrel.
8. Install the sanding drum, sandpaper, and
top and bottom mandrel washers on the		Bottom Mandrel
mandrel, then secure with the mandrel	Insert	Washer
nut, as shown in Figure 46.
9. Choose the insert that has an opening
which is slightly bigger than the sanding
drum chosen (see Figure 46).
• For general drill bits, small reamers, and
miscellaneous small cutting and sanding	Mandrel Nut
bits, use the 5⁄8'' and the 1'' table inserts.
• For the 1'' sanding drum, use the 1 3⁄8''	Figure 46. Sanding drum table insert.
table insert.

•For the 1 1⁄2'' sanding drum, use the 1 7⁄8''

table insert.
	Top Mandrel
	Washer

•For the 2'' sanding drum, use no table insert.

10. Set the chosen table insert into the pocket
	Insert
in the top of the table, insert the sanding
drum mandrel into the chuck, then tighten
chuck (see Figure 47).

11.Loosen and pivot the table so the opening in the installed table insert is centered to the drill bit or sanding drum.

Figure 47. Sanding drum installed.

NEVER sand or drill with- out the table in position and the workpiece secured. Serious person- al injury may occur.

12.Adjust the table height to use all of the grit on the paper as the paper wears.

•If the thickness of the workpiece does not allow much table movement and the sand- ing drum paper is partially worn on one end, remove the drum from the sanding spindle, turn it end for end and replace it on the sanding spindle to use the newer part of the sandpaper.

13.Turn the drill press ON, and begin sanding.

-26-