OPERATIONS
-18-
OPERATIONSStarting the Planer
Once assembly is complete and adjustments
have been made, the machine is ready for a test
run. The purpose of a test run is to identify any
unusual noises and vibrations, as well as to
confirm the machine is performing as intended.
To test run the planer do these steps:
1. Flip the paddle switch up to turn the planer
ON. See Figure 26.
2. Poise your finger over the paddle switch for
emergency shut down if there is a problem.
See Figure 27.
3. Listen for any unusual noises or vibrations,
if unusual noise or vibration exists, shut the
planer OFF immediately.
4. Unplug the planer and remove the safety
lockout key. DO NOT make any adjustments
while it is plugged in. See Figure 28.
5. Investigate the source of the noise or
vibration. DO NOT start the planer again
until the problem is corrected. Contact
Woodstock International Service and
Support at 1-360-734-3482 or send e-mail
to: tech-support@shopfox.biz.
6. Repeat steps 1 through 5until the planer
runs smoothly.
Figure 28. Remove the safety lockout key.
Always wear a dust mask
and safety glasses when
operating this machine.
Sawdust may cause
allergic reactions or
respiratory problems.
Figure 27. Position your finger over the paddle
switch for emergency shutdown.
Figure 26. Toggle the paddle switch for startup
and shutdown.
Make sure loose clothing
and long hair is secured
and kept away from
moving parts.
ON/OFF
Paddle Switch